vWLC issue!!

[saboodi]

I installed vWLC in my lab but my question is this controller support OTAP or not??

Thanks

[Sandeep Choudhary · Accepted solution]

Hi,

As per my knowledge... OTAP is no longer supported on the controllers with 6.0.196.0 and later releases.

Regards

Dont forget to rate helpful posts

[omz · Accepted solution]

The OTAP feature is enabled on the controller GUI from the controller General page or through the CLI with the config network otap-mode {enable | disable} command.

This feature is disabled by default and should remain disabled when all access points are installed.

OTAP is no longer supported on the controllers with 6.0.196 code and above.