02-16-2015 03:46 AM - edited 07-05-2021 02:31 AM
Hello,
I installed a WAP561 at my office, the two radios are activate and I defined 3 VAP, 2 "public" for visitors and one private for employes
I defined Scheduler : enable, Status Enabled/Reason:IsActive,
I defined a profil Weekday from 8am to 7:30pm
In Scheduler Association, I defined :
for radio 1:
WLAN 0, my profile is selected, interface Enabled
VAP0 (my first visitors VAP), profile name is at None and I can't change it!!, interface Enabled
VAP1 (my private), profile is selected, interface Enabled
all other VAP is None, Disabled
for radio 2:
WLAN 1, my profile is selected, interface Enabled
VAP0 (my second visitors VAP), profile name is at None and I can't change it!!, interface Enabled
all other VAP is None, Disabled
In log, my radio seems always running, in the evenning and during week-end.
Could you explain me what is wrong?
Thanks
Bertrand
02-17-2015 05:10 AM
I made a test this morning and It works. I add a profil test that stop in the morning, and my computer lost the connexion.
As I turn "off" radios, it is ok but what I don't undestand is if I only want to schedule vap0, is it possible... why I can't change wlan0:vap0 and wlan1:vap0 ?
Thanks
Bertrand
02-18-2015 02:07 AM
check once if it helps
https://supportforums.cisco.com/discussion/12082216/wap561-keeps-becoming-unresponsive
02-18-2015 04:18 AM
02-27-2015 10:05 AM
Refresh your WAP561firmware and backup your config before that.
after confgurating sheduling make sure its enable from console, normally due to some bug problems Gui don't show what console shows ,so reconfirm it from console side .
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide