Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
686
Views
0
Helpful
1
Replies

WCS 7x > Configure > Ethernet Switches

Jason Aarons
Level 6
Level 6

‎08-18-2011 06:29 PM - edited ‎07-03-2021 08:36 PM

Wireless Control System 7.x

Figure 10-19 Configure > Ethernet Switches

I'm only doing wireless 3502 APs, do I get anything for adding all the switches on my campus into the WCS? Is it just for tracking rogus APs? I'm not clearly understanding why I should all my 3750 switches into WCS.

Labels:
0 Helpful
1 Reply 1

Stephen Rodriguez
Cisco Employee
Cisco Employee

‎08-19-2011 06:23 AM

Jason,

     that is correct, adding your switches to WCS, allows for switchport tracing to find what port a rogue AP is connected to.  you still would need to have an AP in rogue detector mode, and connected to a trunk port so that it can 'hear' arp.

HTH,

Steve

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered
0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card