Wireless

I have been monitoring the alarm summary but have been off couple days and i see one of my controllers is down.  Getting  critical level security and message is port is down on the controller, condition link down.  The other issue is config differenc...

Hi all,could someone let me know the details of the protocol and port utilised in maintaining heartbeats between MSE in a HA  setup?Thanks,

hi there,i' ve got 2 cisco 1130 AG AP's , i want both of them to broadcast 2 ssid's per AP, i've done so far but my clients cannot get a ip adress from the dhcp server.please read my config.txt file out of my AP and tell me were i am going wrongthank...

Hi,I have WiSM with IOS version 7.0.240 (newest available - both controllers have the same version upgraded)The problem is:One laptop connected to AP "A" (CISCO 3502) which is connected to different cabinet using CISCO 2960S to WiSM A using CISCO .Th...

Dears,May I know how I can upgrade my Cisco 3602i (Lightweight) AP to latest IOS ap3g2-k9w8-tar.152-2.JB.tar. SInce the original lightweight IOS 12.X can't join the vWLC.vWLC Version: 7.3.112.0Many Thanks!hang      

Hello Friends,I have a lab scenario wher i have installed ISE1.1 on VM and other hand vWLC7.4 also there in VM i am using 1130AG APs in flexconnect mode and using central auth and central switch.i wan to configure it for CWA(central web Auth) from IS...

I have an ISM-SRE-300 on cisco 1941 does not allow sending of data between clients attached to an AP wired to PC Networking.LAN CLIENT= VLAN 20 10.94.4.0 /24SERVER CLIENTE = 10.94.4.1 D.G= 10.94.4.254ROUTERINT G0/0.1= IP UNNUMBERED VLAN 1 NATIVE VLAN...

Hello guys, I have the next situation,Users have reported an excesive slowly troughput on their PC´s, these production´s  users just use (each user with a respective file and computer ) an specific file ( excel  file) to save information that they ca...

When i try install WCS on windows 2003 it's not possible, after double-click the WCS-STANDARD-K9-6.0.132.0 opened a little page installing "InstalAnywhere" after completed 100% i waited for few minutes but do not return any page.resume: Do not appear...

Dear All,I have a situation where my Cisco 5508 did not come with SFP by default.Can i use the SERVICE PORT to connect the WLC to the Switch1. the controller has 8-SFP Slots 2. one service Port3. On redundant Port

   Hi,what are the series of access point that are supported without WLC. anteena should be in built and capability link 1130ag series.kindly suggestregardsrajat