09-08-2009 10:32 PM - edited 07-03-2021 06:01 PM
Hello,
When we do an audit on controllers we get an error "Audit Report is not available" for some controllers.This is weird as we could perform audits on them before.Any help is much appreciated.
IOS- 5.2.178 WCS-5.2.130
Thanks
Janesha
09-08-2009 11:57 PM
Can you please post the wcs-log file after you recreated the issue and enabled trace level debugging on the WCS?
Also provide me with an approximate time when you recreated it so I can find it in the logs easier.
09-09-2009 03:30 PM
Hi,
Many thanks for your reply.enabled trace level debugging for WCS.However the file comes to 18meg.Would it be possible for you to specify the category (configuration,Monitor,performance Polling etc)you require so we might be able make it a smaller file.
cheers,
Janesha
09-09-2009 03:47 PM
Can you take just the latest wcs-log-x.x.txt file that contains the timestamp with the time when you reproduced it and zip it. It should not be large.
Also make sure to revert back to normal level for the debugging.
09-09-2009 08:09 PM
09-10-2009 04:22 PM
I dont find any relevant error in the log files attached.
Have you tried to refresh the configuration from controller and delete the configuration on WCS when prompted? That may help.
can you post a screenshot of your error?
09-17-2009 06:22 PM
09-18-2009 03:52 PM
Try to remove the particular WiSM from WCS and re add it, see if that helps for the audit:
configure -> controllers, select the 2 WLC in that particular wism that has the issue and remove them.
Then re add them from the same menu.
10-08-2009 03:38 PM
Hi,
Done that. with n luck.I will be rasing this with TAC.
Thanks for all the help :)
cheers,
Janesha
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide