The upgrade process from WGB350v884 to WGB350v885 appears to be broken. Here is the process being following:
1. run upgrade_patch against a WGB352R running V8.84
>This utility is intended to be used on the Cisco >Aironet 350 Workgroup
>Bridge to prepare it for software upgrade.
>
>PLEASE DO NOT REMOVE POWER IN BETWEEN USING THIS >UTILITY AND PERFORMING
>THE SOFTWARE UPGRADE!!!!
>
>Please proceed with caution, this upgrade process >should only be
>performed if absolutely needed.
>
>Would you like to proceed? (y/n)y
>
>Step 1 complete
>Step 2 complete
>Step 3 complete
>Step 4 complete
>Step 5 complete
>Step 6 complete
>Step 7 complete
>Step 8 complete
>
>Your Cisco Aironet 350 Workgroup Bridge is ready to >be upgraded
>in the usual manner.
>
>PLEASE DO NOT REMOVE POWER IN BETWEEN USING THIS >UTILITY AND PERFORMING
>THE SOFTWARE UPGRADE!!!!
2. Attempt to load the 8.85 software
>1 - Get - Load a >firmware/config file
>2 - Put - Send a >firmware file
>3 - Config - Send a >configuration file
>4 - Dest [ 010.012.010.206 ] - Host IP >address
>5 - Username [ "cfgradio" ] - Host >username
>6 - Password - Host >password
>7 - Filename [ "WGB350v885.img" ] - Host >filename
>
>Enter an option number or name, "=" main menu, <ESC> >previous menu
>>
>220-FileZilla Server version 8.8 final
>220-written by Tim Kosse (Tim.Kosse@gmx.de)
>220 Please visit >http://sourceforge.net/projects/filezilla/
>230 Logged on
>200 Type set to I
>200 Port command successful
>150 Opening data channel for file transfer.
>addr 480000 0 != bed4
>226 Transfer OK
>221 Goodbye
Upgrade dies with the addr 480000 0 != bed4
Can you explain what is wrong with the WGB350v885.img file?
Thanks.
