Wireless 1130 AP can't use command line

[martinwsiuda]

I am unable to type anything in the command line of this AP. It has the latest IOS image installed. I can see the output of the bootup process and it loads the IOS image and brings up interfaces and whatnot but it doesn't go to the command line. I have attempted to turn this AP into autonomous mode and feel that I was successful but am still unable to use the command line.

Can someone please help me out?

Thanks

[Scott Fella]

Make sure your port setting is set to:

Baud Rate: 9600

Character Size (bits): 8

Flow Control: Disabled

Stop Bits: 1

Parity: None

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

[KCNicol33]

I was having the same exact problem yesterday.  Disablling Flow Control solved the problem.

Thanks!

[abwahid]

Hi,

Yes make sure your console client terminal setting is same as below and then check.

Bits per Second: select 9600 (or desired baud rate)

Data Bits: select 8

Parity: select None

Stop Bits: select 1

Flow Control: select none