I have 9800-cl configured for centralized authentication but local switching. All APs within the branch are registered with this WLC and same VLAN 1334 associated with particular SSID (SSID: TESTSSID). there is no coverage issue. when i roam within the same floor, sometimes i face issue where i can see that i am connected to SSID but there is no internet and 169 ip is assigned to wireless nic. then i have to disconnect SSID and reconnect and i get another IP with in the subnet. I have tested with following firmware but still facing the same issue. pls see attached debug wireless mac result. in debug it can be seen that i have been assigned 10.x.x.6 and registered with AP_US_AP16 and faced disconnect and then I joined AP_US_AP16 again and then 10.x.x.23 was assigned later.
Hello Community, I have an issue where APs do not connect to the WLC. Connection is made over VPN. Until yesterday all 3 APfailed with below errors. We change the LAN connection to a cisco router and now one of the AP magically connected to the...
Where to download
Attached files on this post
Alternatively, cloud version (only summaries)
New implementation for the WLC Config Analyzer. it is a new re-write of the application, with clean up and improved checks
Support for IOS...
Cisco Champion Radio · S8|E6: Fastlane+ Optimizes Network and Device Communication
Cisco Fastlane+ is a co-developed solution with Apple that significantly improves the experience of any Wi-Fi 6 capable iPhone or iPad connected to a Cisco Catalyst 9130 A...
We are pleased to announce the immediate availability of the IOS-XE release 17.4.1 for the Catalyst Wireless Controllers. The new code is now posted on the CCO and can be found at this link:
Table of Contents
The purpose of this document is to provide step-by-step instructions regarding how to connect your read-only Catalyst 9800 WLC or AireOS WLC with Cisco DNA Center for Assurance monitoring through manual configuration. I...