Wireless Bridges

bob.forster · ‎02-17-2003

350 Bridges, 2 remotes. 1 Remote fine, second remote Re-Associates every half hour or so. Set to only run at 1 or 2 Mbps.

All Bridges are 12.0 Code. Everyhting well within Calculated Parameters.

Alignment test shows: (averages)

Signal Strength 50%, -70dBm

Signal Quality 93%

Is this alignment test reasonable?

Bob

derwin · ‎02-17-2003

Bob I have noticed you have made 3 post all very similar are these all for the same link ?

The above readings are good.

Please try 12.01T1 firmware

Do you see many CRC errors ? What is the distance between the bridges ?

bob.forster · ‎02-18-2003

David,

A question.

If I go to a higher gain Omni at the Central Site, will be of any benefit?

(Currently a 5.2bBi Omni)

If it noise or interference related, will pounding thru a stronger signal help any.

The remote has a 13.5dBi Yagi now.

We are going to try a 13.5Yagi to 13.5 Yagi point to point tomorrow.

Bob

derwin · ‎02-18-2003

Bob,

You can use this spreadsheet to calculate the link budget with different antenna