
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-07-2022 01:47 AM
Good Day,
Checking this matrix:
(For AP's compatible with WLC Firmware Version: 8.5.160.0)
https://www.cisco.com/c/en/us/td/docs/wireless/compatibility/matrix/compatibility-matrix.html
The matrix lists AP models 1600, 2600, 2800 ect.
I am 99% sure above listed models includes AIR-CAP1602I-E-K9, AIR-CAP2602I-E-K9, AIR-AP2802I-E-K9.
Most importantly it seems WLC Firmware Version: 8.5.160.0 supports Outdoor Aironet 1562E
If anybody can confirm the compatibilities I will apricate it.
Thanks & Regards
Solved! Go to Solution.
- Labels:
-
Wireless LAN Controller
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-07-2022 07:04 PM
Just to add, you can drop the "2" at the end of the model. 1602 would be listed as 1600, the same for a 9130, would be 9100, etc. The models you have listed is in the compatibility for the version of code from 8.5.103.0 all the way up to 8.5.182.0.
*** Please rate helpful posts ***
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-07-2022 02:10 AM
as per matrix the model listed supported.
Most importantly it seems WLC Firmware Version: 8.5.160.0 supports Outdoor Aironet 1562E
look at the bottom of the page as i see it only support until 8.3.X controller....this need to check
Note : check compatabilityu against controller also. not only with AP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-07-2022 02:12 AM
I had the 2802 and 1562 running on my WLC 2504 with software 8.5.171.0. Yes, they work. I didn't have the 1600 and 2600 running with 8.5, but at least they are listed in the Matrix *and* the release notes.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-07-2022 07:04 PM
Just to add, you can drop the "2" at the end of the model. 1602 would be listed as 1600, the same for a 9130, would be 9100, etc. The models you have listed is in the compatibility for the version of code from 8.5.103.0 all the way up to 8.5.182.0.
*** Please rate helpful posts ***

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-08-2022 12:56 AM
Thank you for the reply / info
Regards
