03-10-2016 02:31 PM - edited 07-05-2021 04:45 AM
I have a 2504 running 8.1.102.0 for some reason it is constantly generating a SNTP error that it is unable to send a NTP packet. It appears to be trying to send this to an all IPv6 address of "::"
I have disabled ipv6 on the Controller under global policy, wiped out my NTP servers and re configured as well as rebooted the controller.
Still the rrors persist - even if I wipe out ALL NTP servers and just go with local time
Any thoughts?
03-10-2016 08:47 PM
Post the output to the command "sh ipv6 summary".
03-10-2016 08:54 PM
show ipv6 summ
Global Config............................... Disabled
Reachable-lifetime value.................... 300
Stale-lifetime value........................ 86400
Down-lifetime value......................... 30
RA Throttling............................... Disabled
RA Throttling allow at-least................ 1
RA Throttling allow at-most................. 1
RA Throttling max-through................... 10
RA Throttling throttle-period............... 600
RA Throttling interval-option............... passthrough
NS Mulitcast CacheMiss Forwarding........... Disabled
NA Mulitcast Forwarding..................... Enabled
IPv6 Capwap UDP Lite........................ Enabled
Operating System IPv6 state ................ Disabled
03-11-2016 12:33 AM
Could be a bug. Try using 8.1.131.0.
03-11-2016 08:22 AM
I've upgraded the Controller and APs to 8.1.131.0 (which was a good learning experience.) Unfortunately I still have the error
03-11-2016 03:13 PM
Ok, how about issue the command "sh time"?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide