Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, We have a Cisco CUCM deployment in our environment. I'm wondering if there might be a way to use CLI / PowerShell / Whatever to query our CUCM for whatever DN is associated for a provided MAC address. The idea here being this is easier to write ...
We're running FTD 7.x on various FPR 2100 and 1100s. We have an asymmetric tunnel that we need to be able to sed pings through. TCP Bypass is working fine, but the ASP is dropping return echo-replies. Our understanding is that by disabling ICMP inspe...
Hi, I'm having this annoying problem with a non-FMC managed FTD device of ours (based on ASA5516X platform). The unit is cabled via the recommended setup documentation whereby the management and internal interfaces are connected via L2 switch to e...
Hi,I'm trying to use some combination of route-maps and / or ACLs to write a destination-based NAT policy that would essentially do the following: Take any source address of 10.x.x.x/8 and if it is going to (list of subnets) than NAT to (host IP) and...
I understand that Cisco devices will accept Linux REGEX commands (eg grep, grep -v, more, etc) after being issued the command "shell processing full" from global configuration. I've tried this on ASR1K, ISR4K, Cat9K, and even a 2911 with IOS 15.x.x. ...
You are totally correct. I found this after I replied to the other post and just flat forgot to add the comment. I used ot be smarter and more on top of things but... time marches on
If memory serves we ended up with just doing a bi-directional prefilter that allowed everything. A better solution (which we plan to migrate to soon) is to enable BGP with the remote peer and then set a metric on one path so that only the other path ...
