Wireless Controller

[richprime890]

Hi all, new here, am deploying a wireless network using the Cisco WLC series 9800 and APs, APs have successfully joined the controller but the SSIDs i created are not been broadcasted from the APs. Have anyone face this challenge before kindly advise.

[balaji.bandi · Accepted solution]

what is the IOS XE code running on the device - upgrade to latest 17.9.4a for stability, what model of AP

based on experience below need to check :

•  Ensure your AP get sufficient PoE power
• NTP
• Verify that Country on WLC code matches with the AP model number.
• 802.11b/g/n and 802.11 a/n/ac are enabled under wireless.
• Check AP Profiles.
• SSID is in enabled state.
• SSID is being broadcasted.

[Mark Elsen]

 - Have  a checkup of your  9800 WLC configuration with the CLI command show tech wireless and feed the output to : Wireless Config Analyzer

 M.

[Mark Elsen]

 - Added reply : also use the CLI command  wireless config validate

 M.

[j.reichert]

Make sure your SSID's are added to the policy tag you are using for these APs. Are you using more than one policy tag or just the default?

[j.reichert]