wireless not working login

[TimMees60387]

I have a problem with my Cisco wireless, the login is incorrect, does anyone know a solution?

[Enes Simnica]

hello @TimMees60387. If u're seeing an "incorrect login" error on ur Cisco wireless device, here are a few things to check:

• Default Credentials: Try admin/admin or check if someone has changed them. Some models may not require a username.
• Console Access: Use a console cable and terminal software (PuTTY) to connect directly. This is helpful if the GUI or SSH isn't working.
• Password Recovery: Most Cisco devices allow recovery by interrupting the boot process. The steps depend on your model.
• Factory Reset (last resort): If recovery fails and u're still locked out, a factory reset will wipe all settings, so make sure you have backups.

also check these links G:

• https://www.youtube.com/watch?v=QbtYfWlsLuw 
• https://id.cisco.com/oauth2/default/v1/authorize?response_type=code&client_id=CWAY.CliWeb.PRD&redirect_uri=https%3A%2F%2Fcway.cisco.com%2Foauth%2Fvalidate-auth.html&scope=openid+profile+email&state=cli__Cs721lQ0JxlRJeN 

hope it helps G

-Enes

[marce1000]

@TimMees60387   - That is not enough info to proceed with, what is the cisco wireless component or components you are talking about ? Are you  talking about administrative access or user access ?

  M.

[TimMees60387]

it's about cisco 892W after

 

[marce1000]

  - @TimMees60387    Did you try the default credentials cisco/cisco as being mentioned on the login screen ?

  M.

[TimMees60387]

not working tried several times

[marce1000]

 - @TimMees60387   Check if these info's can help you : https://www.cisco.com/c/en/us/support/docs/routers/800-series-routers/12065-pswdrec-827.html

  M.

[TimMees60387]

this for wireless module the password

[marce1000]

   - @TimMees60387      Probably the only way to get out is to reset the wireless module

                             Try service-module wlan-ap 0 reset default-config
                                       and then reset the AP module
                                 service-module wlan-ap 0 reset

                                 You may then only need an enable password for connecting to it (getting privileged access)
                                 which is  Cisco 

  M.