wlan controller connections

[juanluisrodriguez]

I have two options when connecting wlan controller 4404:

1) to a 2600 router (outside internal lan)

2) to a 2900 catalyst (inside lan)

Which one should I take as the best one ?

[pradeepde]

By default, controllers block Telnet sessions. You must use a local connection to the serial port to enable Telnet sessions.

direct ASCII serial connection to the controller console port

A remote console session over Ethernet through the pre-configured Service Port or through Distribution System Ports

Before you log into the CLI, configure your connectivity and environment variables based on the type of connection you use