WLC 2100 configuration

[Yamani313]

Hello,

I have 2100 wlan controller and wlapp ap connected to switch (catalyst 3560).

when I configure the controller with basic configurations , I can not access the webmode anymore with the management ip interface.

can you help me please.

Br

Yamani

[Surendra BG · Accepted solution]

Hi Yamini,

Issue the command "show network summary" on the WLC cli and verify whether the WEBMODE is enabled.. if not then issue the command..

"config network webmode enable"  and try accessing the GUI.. if we have enabled the Webmode and still not able to access then, check for the duplicate IP assigned...

Regards

Surendra