05-18-2012 06:39 AM - edited 07-03-2021 10:11 PM
I have a fairly simple WLC 2100 configured to control two APs. We had a power outage a few days ago, and though the WLC was on a surge protector, it did not come back up properly after the outage. The STATUS light sticks at amber and I can't get any console response. At this point I'm not sure what to do except replace the WLC, though I'm loathed to do that as our budget was just cut substantially for next year and we're trying to turn nickels into pennies.
Thanks much!
Solved! Go to Solution.
05-18-2012 06:43 AM
You should be fine with getting it RMA'd:
http://www.cisco.com/en/US/docs/general/warranty/English/LH2DEN__.html
05-18-2012 06:43 AM
You should be fine with getting it RMA'd:
http://www.cisco.com/en/US/docs/general/warranty/English/LH2DEN__.html
05-18-2012 07:37 AM
Thanks for the prompt reply. Now I have to go digging through paperwork looking for when it was purchased and from whom! Just started working here 9 months ago...
05-18-2012 07:41 AM
Should still be under your company hoepfully. Since its not past 5 years of EOL you will be able to RMA that device.
05-18-2012 07:43 AM
Take a look at this thread... you should just be able to call it in I would think:
https://supportforums.cisco.com/message/3495435#3495435
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide