WLC 2504 EtherChannel

[Questions]

Will configuring WLC 2504 EtherChannel clear traffic?

WIFI is slow these days.

I heard WLC 2504 has a throughput of 1G.

Can I say that configuring EtherChannel can relieve traffic?

[Sandeep Choudhary · Accepted solution]

I am using etherchannel for 2504 WLC and getting good speed.

Best would be to check the WLAN configuration again.

Regards

Dont forget to rate helpful posts

[Scott Fella]

If you are worried about 1gig throughput, I have seen many customers have a single 1gig link connected on their controllers and not even coming close to 80% utilization on the switchport. These are with 100+ access points also. This is another reason Cisco scaled down the number of ports on their newer appliances, because they have worked with customers and also have seen what was being used.
If you have issue with slowness, then it’s something else.