WLC 2504 Migration Path

[Alejandro.Angon]

Hi,

I have a WLC 2504 and I need to upgrade it from 7.0.116.0  to 7.3.112.0 software version. I sow at the 7.1.91.0 release download page an advertisement that says "Migration path is from 7.1 to 7.2 Release" so I would like to know if I need to upgrade from 7.0 to 7.1 and after to 7.3 release code or if it´s posible to do it directly from 7.0 to 7.3

thanks a lot for your help

[Leo Laohoo · Accepted solution]

Yes you can upgrade direct from 7.0.98.X.

[Alejandro.Angon]

hi leolaohoo,

do you know any reference about this?, I need to be very sure of the procedure because the WLC service is critical

thanks a lot for your help.

[Leo Laohoo]

Table 4:  Upgrading to Controller Software Release 7.4.100.0

[Saurav Lodh]

You can migrate that way. Please see the image

[Alejandro.Angon]

Hi,

I have just upgraded the WLC directly form 7.0.116.0 to 7.3.112.0 without any problem. I have many  flexconnect APs and I didn´t lose any VLAN mapping as it would happend triying to upgrade to 7.4.100.0

http://www.cisco.com/en/US/partner/docs/wireless/controller/release/notes/crn7_3_112_0.html#wp1057104

best regards

[asadmtz01]

can we limit bandwidth on wlc 2504.?

[Sandeep Choudhary]

No you can not , on 5508 model you can.

Regards

Sent from Cisco Technical Support iPhone App

[Leo Laohoo]

can we limit bandwidth on wlc 2504.?

Depending on what firmware you are using you can limit bandwidth in two ways:

1.  Limit bandwidth on SSID; or

2.  Limit bandwidth per user.

[Sandeep Choudhary]

The WLC2504 does not support per-user or per-WLAN QoS. Only the 5508 and up support those features.

Regards

Dont forget to rate helpful posts

[asadmtz01]

and what about per interface. bandwidth limit.?

[Sandeep Choudhary]

Not supported on 2504 WLC.

Regards
Don't forget to rate helpful posts

Sent from Cisco Technical Support iPhone App