wlc 2504 not join ap1130ag

[master.mohammed]

hi

I have a problem in join my ap1130ag in my wlc 2504

i activate dhcp internel (172.19.1.50 ----> 172.19.1.60) in wlc and this wlc affected adresse for ap1130ag (172.19.1.51)

wlc and ap1130ag is connected with switch  2960 (port 17,18)

this port the switche is configured in trunk mod alowed all vlan

then my wlc not detected ap1130ag

please if you understand  open my problems

and Thanks

[maldehne]

please have the following outputs attached:

WLC>show inteface detailed management

On the switch

show run int < interface at which the AP is connected >

show run int < interface at which the controller is connected >

[master.mohammed]

thanks for your repply

WLC>show inteface detailed management

Interface Name................................... management

MAC Address...................................... 6c:20:56:b8:d8:40

IP Address....................................... 172.19.1.1

IP Netmask....................................... 255.255.255.0

IP Gateway....................................... 172.19.1.1

External NAT IP State............................ Disabled

External NAT IP Address.......................... 0.0.0.0

VLAN............................................. untagged

Quarantine-vlan.................................. 0

Active Physical Port............................. 1

Primary Physical Port............................ 1

Backup Physical Port............................. Unconfigured

Primary DHCP Server.............................. 172.19.1.1

Secondary DHCP Server............................ Unconfigured

DHCP Option 82................................... Disabled

ACL.............................................. Unconfigured

AP Manager....................................... Yes

Guest Interface.................................. No

L2 Multicast..................................... Disabled

------------------------------------------------------------------------------------------------------------------------------------------------

show run int < interface at which the AP is connected >

sh run interface fa0/20

Current configuration : 85 bytes

!

interface FastEthernet0/20

switchport access vlan 100

switchport mode trunk

end

----------------------------------------------------------------------------------------------------------------------------------------------

show run int < interface at which the controller is connected >

sh run interface fa0/18

Current configuration : 85 bytes

!

interface FastEthernet0/18

switchport access vlan 100

switchport mode trunk

end

[maldehne]

first thing

in the management vlan configuration you have configured the interface ip address to be the same as the default gateway ip address which is completely wrong.

second thing you should configure the interface connecting the ap to be access port normally

int fa0/20

switchport mode access

switchport access vlan 100

now for the port on which the controller is connected, normally it should be trunk

now the question the ip range 172.19.1.0 /24 represented by which vlan id on your routing

device??

-----------------------------------------------------------------------

Please make sure to rate correct answers

[master.mohammed]

thanks for your reply

i solve my probleme by conversion ap1130ag to lwapp mod

i suived this video     http://www.youtube.com/watch?v=wWDrFjwVNb0

my current problems is ap no accepte some commande (ex :conf t)