WLC 3504 change port mode

[adminadmin7605]

Hi all,

i need to change mode on one port (from auto to manual) on my 3504. i've tried with command "config port autoneg 3 disable" but command is not reconized. does someone knows how to change it ?

thanks,

[patoberli]

I don't think this is possible.
But why do you want to do that? With Gbps interfaces it's better to leave it on Auto (speed and duplex).

[adminadmin7605]

My router is special, autoneg must be disable (link is ok but no traffic). Port speed must be set to 100.

[patoberli]

I think then it's time to add a gigabit switch between the router and the WLC.

It should work if only one side is fixed, but I really can't recommend it.

[Scott Fella]

Take a look at the deployment guide, these ports are gigabitethernet/mGig. 10/100 is not supported.

https://www.cisco.com/c/en/us/td/docs/wireless/controller/technotes/8-5/b_WLC_3504_Release_8_5_Deployment_Guide.html#concept_5D5FA47A14404D65A3FA95AE8474D794