WLC-5500 Authorization failed. no sufficient privileges to save configuration

[winaicas1]

Help me!

I have Cisco 5500 Version 7.5
I log in using the admin settings 
But can not save save config

Thank you

[Sandeep Choudhary · Accepted solution]

May be you set the read-only privileges for the admin user in RADIUS SERVER !!!

Please check again.

Check this posts, it may helps:

https://rscciew.wordpress.com/2014/06/19/wlc-authentication-by-ise-server/

http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wlan-security/71989-manage-wlc-users-radius.html

Regards

Dont forget to rate helpful posts

[winaicas1]

Use it to set up a user admin can manage it. But it still does not fix the system.

[Sandeep Choudhary]

Did you configure RADIUS server correctly, please check my last post and try to recheck again.

https://rscciew.wordpress.com/2014/06/19/wlc-authentication-by-ise-server/

http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wlan-security/71989-manage-wlc-users-radius.html

Your Auth order is First RADIUS and then Local. So if If LOCAL is selected as second priority then user will be authenticated against LOCAL only if first priority is unreachable.

Regards

Dont forget to rate helpful posts

[winaicas1]

In this case, however, I can fix it.
I Selection Priority Order> management User First is Radius ????.
I got into the mode console irreparable.

I use Freeradius + openldap

***Normally the user admin in local wlc.

Thank you

[winaicas1]

succeeded.

By disconnecting radius.

Making adjustments Priority Order> management User First is Local