Wireless

HiI recently bought a WLC 2504 with a few AP 1702. During installation I noticed that WLC 2508 had a firmware 7 and the AP's had firmware 8. Due to this reason they wouldn't communicate with each other. Yesterday I received from my supplier the right...

Hi guys,Hope you can help me, I have just been asked a question at the interview if wirelesses operates at half or full duplex and honestly I don't know if my answer was correct. Can someone tell me which one is correct and what's more important,why ...

Hi,I have 14 LAP 1252 that immediately gives me 3 solid red lights when I give them power.By reading this thread: https://supportforums.cisco.com/discussion/11009731/1252-lapI see that if we are still under warranty or with an associated contract the...

Hi All, I need to add controllers into Cisco Prime using the REST API. I am able to get information out of the REST API, but it seems the documentation on the POST and PUT calls are only shown for config templates. Can someone please shed some light ...

Hellow to all,Can I do acknowledge all of this error for WLC, (Signature attack  and Audit status difference

Hi all,I have been facing roaming issue where solution Client -based ( High Density AP deployment). All AP's are in flexgroup and authentication method is 802.1x.I have customised the RF environment with RF profiles( power level max 17dbm for both th...

Dear Guys, Currently i am building a WLC setup , where i setup two WLC in active / standby configuration. Currently i am using version  7.4.121.0 on all three controller. two for LAN and one is guest controller.Active / Standy work fine But i am not ...

Anyone who can give me tips about config Aironet 1602 for a roaming network? In our warehouse we have 3 accesspoints Aironet 1602 to have a full coverage, all configured with the same SSID and security key.We work with Motorola terminals for orderpic...

Hi.I am hitting this bug CSCuq15784 - Intermittently MSE still goes unreachable  on MSE 7.6.120 and Prime Infrastructure 2.1.2.is someone knows what workaround can I perform and if there any fix or should be in the future?Thanks,Moti.   

Hi,I have 2602 AP and i rebooted after rebooting i could not joining the controller (2502) and getting the following logs. Kindly suggests me any solution. Moreover after rebooting AP showed the admin "status disable" and clean air status is "down". ...

We have CISCO CAP1602I-N-K9 and we configured as a standalone AP .Connected on network .WIFI users getting 25 MBPS on same network LAN users getting 90 MBPS any configuration required on AP.

It doesn't seem to matter what we do for telling APs what controllers they should be on, our environment sees a lot of APs jumping off of a controller and going to another one (code version irrelevant). Today's example- an 8510 has thousands of APs a...

Hello, I have to perform a wireless site survey of a new building with 5 floors, ~1000 square meters each. According to you how many APs I have to use during the survey. Do I have to bring there the total number of APs from the predictive site survey...

HiI am looking for a WiFi echo system.Here is what i would like to achieve, User enters a premisisConnects to open SSIDPresented with a landing page to enter its Mobile numberA code is sent to the mobile - entered and get internet accessUser mobile n...