Hi every one
before 4 days ago i setup a new WLC 5508 , firstly i updating his image to compatible with 1142 AP , and everything working normally , and APs connected with WLC normally , after 2 days of normally working the WLC stop working and the light of ( SYS & ALM ) light up orange , then i reset the WLC and connected console and this logging appear :
WLCNG Boot Loader Version 1.0.20 (Built on Jan 14 2014 at 11:40:45 by cisco)
Board Revision 1.3 (SN: FCW1623L033, Type: AIR-CT5508-K9) (P)
Verifying boot loader integrity... OK.
OCTEON CN5645-NSP pass 2.1, Core clock: 600 MHz, DDR clock: 330 MHz (660 Mhz dat a rate)
FPGA Revision 1.7
Env FW Revision 1.8
USB Console Revision 2.2
CPU Cores: 10
DRAM: 1024 MB
Flash: 32 MB
*** Warning - bad CRC, using default environment
Clearing DRAM........ done
Network: octeth0', octeth1
' - Active interface
E - Environment MAC address override
CF Bus 0 (IDE): OK
IDE device 0:
- Model: STEC M2T CF 1.0.0 Firm: K1367MIX Ser#: STIM2M1312033010824
- Type: Hard Disk
- Capacity: 977.4 MB = 0.9 GB (2001888 x 512)
Press <ESC> now to access the Boot Menu...
Loading primary image (8.3.140.0)
84%
____________
then another reset :
WLCNG Boot Loader Version 1.0.20 (Built on Jan 14 2014 at 11:40:45 by cisco)
Board Revision 1.3 (SN: FCW1623L033, Type: AIR-CT5508-K9) (P)
Verifying boot loader integrity... OK.
OCTEON CN5645-NSP pass 2.1, Core clock: 600 MHz, DDR clock: 330 MHz (660 Mhz data rate)
FPGA Revision 1.7
Env FW Revision 1.8
USB Console Revision 2.2
CPU Cores: 10
DRAM: 1024 MB
Flash: 32 MB
*** Warning - bad CRC, using default environment
Clearing DRAM........ done
Network: octeth0', octeth1
' - Active interface
E - Environment MAC address override
CF Bus 0 (IDE): OK
IDE device 0:
- Model: STEC M2T CF 1.0.0 Firm: K1367MIX Ser#: STIM2M1312033010824
- Type: Hard Disk
- Capacity: 977.4 MB = 0.9 GB (2001888 x 512)
Press <ESC> now to access the Boot Menu...
Loading primary image (8.3.140.0)
100%
36372622 bytes read
Launching...
__________________
the ALM&SYS staid light orange , after that I shutingdown the WLC and i wating about 10 min and turn on again , then th WLC working normally ?!!!!!
is this problem with image ! or another thing !
BEST REGARDS
