06-16-2016 03:16 AM - edited 07-05-2021 05:14 AM
Hi,
I am having two 8510 wlc in HA, it was working fine till now, but now am seeing a message in Redundancy menu that standby controller went into "Maintenance mode" and the message its showing as "default gateway not reachable" .
Can anyone guide how to fix this issue?
Solved! Go to Solution.
06-16-2016 03:27 AM
HI Zaid,
Which Sw version you are running ?
If the controllers cannot reach each other through the redundant port, the primary controller becomes active and the standby-hot controller goes into the maintenance mode.
These could be the reason:
Solution:
1. Check the cable connectivity between both WLCs(Redendent ports)
2. The WLC should be rebooted in order to bring it out of Maintenance Mode.
Regards
Dont forget to rate helpful posts
06-16-2016 03:27 AM
HI Zaid,
Which Sw version you are running ?
If the controllers cannot reach each other through the redundant port, the primary controller becomes active and the standby-hot controller goes into the maintenance mode.
These could be the reason:
Solution:
1. Check the cable connectivity between both WLCs(Redendent ports)
2. The WLC should be rebooted in order to bring it out of Maintenance Mode.
Regards
Dont forget to rate helpful posts
06-19-2016 01:16 AM
Hi guys,
Did the above steps, it worked after reboot.
Thanks:)
06-16-2016 08:21 PM
There are few scenarios where the Standby WLC may go into Maintenance Mode and not be able to communicate with the network and peer:
Note The WLC should be rebooted in order to bring it out of Maintenance Mode. Only the Console and Service Port is active in Maintenance Mode.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide