01-23-2024 03:32 AM
Hi,
I need an overview from all the access points and the assigned PoE (Power Status).
Due to sometimes bad cabling an AP is running on Medium PoE, but there is no warning (except flashing color leds).
I have tried it with: show ap config general | include AP.Name|Power.Type/Mode
But that won't filter out the Medium PoE (it's creates a big list with all the AP's).
Also within the Gui, I can only find the Power status on each AP seperatly.
Anyone has any better idea?
Thnx.
01-23-2024 09:55 AM
- You may try :
show ap name <ap name> lan port summary
Yet I doubt if the controller is the right place to query a part of the AP network connection , perhaps better look at the POE-statuses from the switch (switching) point of view (and or querying through snmp for example).
M.
01-23-2024 11:47 PM
Hi,
Thnx, but that would mean I would have to check per AP or per switch, and it would not generate a full overview.
01-24-2024 12:58 AM
@bram.a - You need to consider that you won't get it done on the controller ,
M.
01-24-2024 01:15 AM
Two things I afraid suggest about it
1- admin
2- PoE
But I will try help you here'
In cisco SW for max power we need lldp and 4 wiring pairs.
Check this point in your SW
Again friend be worried anything wrong can damage your SW port
Goodluck
MHM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide