cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2892
Views
0
Helpful
4
Replies

WLC 9800 is presenting its own certificate

nino1
Level 1
Level 1

I am having a strange issue with WLC 9800 17.3 configured for guest wifi access in CWA scenario. It seems that whenever user is trying to access web page WLC is presenting its own certificate instead of redirecting to url provided by ISE. Any idea what could be causing this

1 Accepted Solution

Accepted Solutions

Personally yes i guess so as long as working, just monitor - test it, take feedback from users (is the best ) to see all working as expected.

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

View solution in original post

4 Replies 4

balaji.bandi
Hall of Fame
Hall of Fame

we are not sure how the configuration done at your end : best is i suggest look at below document provide more information, how the redirecting taking place :

 

 

Look at the below document :

 

https://www.cisco.com/c/en/us/support/docs/wireless/catalyst-9800-series-wireless-controllers/213923-configure-a-web-authentication-ssid-on-c.html

 

 

look at the thread :

 

https://community.cisco.com/t5/wireless/migrating-to-cisco-9800-certificate-requirements-when-using-ise/m-p/4285926

 

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Hi Bandi,

it seems like we found the issue. This is Foreign/Anchor setup with CWA
used to authentication. What we found out was that we had
ip http server (on Foreign)
and
no ip http server (on Anchor)
we are running 17.3.1
What fixed it was doing it the other way arround

no ip http server (Foreign)
ip http server (Anchor)

and it started working. Now, I am not sure does this make sense?
The problem was seen as after MAB phase ISE would return ACL + redirection
URL to Foreign WLC but user would never be redirected to this url for some
reason
After the change explained above the things started working

Is this expected behavior?

Regards
Nino

Personally yes i guess so as long as working, just monitor - test it, take feedback from users (is the best ) to see all working as expected.

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

you can keep (no ip http server) on both WLCs Foreign and Anchor but you need to do the below:

conf t
parameter-map type webauth global
webauth-http-enable

Starting from 17.3.1 there is new cli commands to enable/disable http/https on the WebAuth, this was listed here in the release notes https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/17-3/release-notes/rn-17-3-9800.html

 

Review Cisco Networking for a $25 gift card