10-13-2021 10:07 AM - edited 10-13-2021 10:07 AM
Using packet tracer, I configured DHCP pools in a L3 Switch.. but hosts connected to APs, cannot get the right IP addresses! In simulation mode, I saw that switch ports that are connected to APs are blocked by STP!
Enclosed you will find a capture of my topology!:
10-13-2021 11:38 AM
How do you configure those AP-connected switch ports (g1/0/4)? It should configure as "Acces Port" on a particular vlan.
If port is blocke by STP mean some sort of layer 2 switching loop or AP sending BPDU
HTH
Rasika
*** Pls rate all useful responses ***
10-14-2021 06:29 AM
And remember packet tracer is a piece of training software only designed to emulate the exercises it's built for.
It is not actual network equipment so not everything works or works the same as the real device.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide