Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

For secuirty purposes I have created ACL for new SSIDs and looks like it does not work correctly.  10.2.25.0 is the interface of new SSID trying to get access to 10.2.115.0 which are APPLE TVs  basically when I take off the ACL all is working, when I...

jguremka1 by Beginner
  • 381 Views
  • 1 replies
  • 0 Helpful votes

This summer the IT department at my location rolled out a little more than 100 AIR-CAP3502I-A-K9's to much success. We have had an issue with only one AP. This paticular AP must have gotten unplugged during the updating process after the initial conn...

ConMiMente by Beginner
  • 39079 Views
  • 8 replies
  • 0 Helpful votes

Hi all- I am looking for a wireless bridge - to plug in a wired device and access the wireless network.  I would prefer a device that does EAP-TLS.  We have been using APs in workgroup-bridge mode, but I am hoping to reduce the complexity and price a...

Hi , we have 2 SSO pair 5508 controllers. we were planning to upgrade from 8.3 version to 8.5.161.0.we had a weird situation last week,while standby peer was down, we uploaded the new image to the primary one, and image uploaded successfully to the p...

mbay by Beginner
  • 373 Views
  • 5 replies
  • 0 Helpful votes

Have a few 1832i(s) that came w/ the CapWap image that I'd like to get going w/ ME instead.  I've converted 1 of them to the ME image and I'm able to get into the controller and begin the setup.  I have the others on the same vlan as the controller s...

mumbles202 by Enthusiast
  • 389 Views
  • 3 replies
  • 0 Helpful votes

Hello everybody,Might look a noob question : I'm trying to understand WLAN environment of a client but i'm lost a little bitMy understanding of WLANs is as follows :WLAN created = linked to an interface, which will play the role of a DHCP relay and g...

TrickTrick by Participant
  • 528 Views
  • 10 replies
  • 0 Helpful votes

Hello Great Community,I'm new to CISCO MESH APsI 'm assigning the static IP addresses to my pre exist Cisco Outdoor Mesh Access Point but by mistake I have given same static IP of WLC to one of my Cisco Outdoor Mesh AP. Though I lost the connectivity...

Murshad by Beginner
  • 427 Views
  • 1 replies
  • 5 Helpful votes
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers