WLC & APs

[Netzwerker]

Using packet tracer, I configured DHCP pools in a L3 Switch.. but hosts connected to APs, cannot get the right IP addresses! In simulation mode, I saw that switch ports that are connected to APs are blocked by STP!

Enclosed you will find a capture of my topology!:

[Rasika Nayanajith]

How do you configure those AP-connected switch ports (g1/0/4)? It should configure as "Acces Port" on a particular vlan.

If port is blocke by STP mean some sort of layer 2 switching loop or AP sending BPDU

HTH

Rasika

*** Pls rate all useful responses ***

[Rich R]

And remember packet tracer is a piece of training software only designed to emulate the exercises it's built for.

It is not actual network equipment so not everything works or works the same as the real device.