01-16-2019 01:11 AM - edited 07-05-2021 09:41 AM
Hi to all,
I have two old wlc4402 with release 7.0.235.3 and I have new wlc 3504 (into DMZ for guest access) release 8.5.131.0. Is it possible to do an anchor configuration for wlan guest?
thanks a lot
Roberto
01-16-2019 02:51 AM
- What do you mean, in this case , by anchor configuration ?
M.
01-16-2019 03:38 AM - edited 01-16-2019 03:48 AM
thanks for support,
anchor configuration it's mean configure a wireless lan for guest users.
This is the link that explan the configuration.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/Enterprise-Mobility-8-5-Design-Guide/Enterprise_Mobility_8-5_Deployment_Guide/WirelessNetwork_GuestAccessService.pdf
Is it ok?
01-16-2019 06:04 AM
most likely it will work, you are running most recent (?) version on the 4400?
Can I create Ethernet over IP (EoIP) tunnels between controllers that run different software versions?
Not all Wireless LAN Controller software versions support this. In such cases the remote and anchor controller should run the same version of WLC software. However, the recent software versions do allow the remote and anchor controllers to have different versions.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide