"show ap config general <ap_name>" is what you want
(WLC01) >show ap config ?
802.11-a49 Display information for 802.11a 4.9 GHz radio.
802.11-a58 Display information for 802.11a 5.8 GHz radio.
802.11-abgn Display information for DualBand 802.11a/b/g/n.
802.11a Display information for 802.11a.
802.11b Display information for 802.11b/g.
dns Display DNS Config Info
ethernet Display Ethernet Vlan tagging Info
general Display Common information for Cell
global Display global settings for all Cisco AP.
slot Display Common information for Slot
(WLC01) >show ap config general AP025
Cisco AP Identifier.............................. 17
Cisco AP Name.................................... AP025
Country code..................................... AU - Australia
Regulatory Domain allowed by Country............. 802.11bg:-A 802.11a:-NZ
AP Country code.................................. AU - Australia
AP Regulatory Domain............................. -Z
Switch Port Number .............................. 13
MAC Address...................................... 50:87:89:a9:51:28
IP Address Configuration......................... DHCP
IP Address....................................... 10.10.6.104
IP NetMask....................................... 255.255.255.0
Gateway IP Addr.................................. 10.10.6.250
NAT External IP Address.......................... None
CAPWAP Path MTU.................................. 1485
DHCP Release Override............................ Disabled
Telnet State..................................... Globally Disabled
Ssh State........................................ Globally Disabled
Cisco AP Location................................ south end carrels ap 2
Cisco AP Floor Label............................. 758047434092839594
Cisco AP Group Name.............................. APG-1
Primary Cisco Switch Name........................WLC01
.
.
HTH
Rasika
*** Pls rate all useful responses ***
