cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
512
Views
10
Helpful
3
Replies

WLC pointing 2 different WLAN's to different DHCP servers

scdigital
Beginner
Beginner

I have a WLC 2106 which is configured and working as follows:

Site A:

Network: 10.0.0.0/22

3 AP's configured

Radius authentication configured on local server

DHCP handed to clients via local server

Site B:

Network: 10.0.28.0/22

Radius authentication configured on local server

1 AP connected. I have created a new WLAN for this AP

My question is how do i get the AP at Site B to use the local server (10.0.28.x) to hand out DHCP leases?

Thanks

3 Replies 3

Stephen Rodriguez
Cisco Employee
Cisco Employee

You would need to configure the AP at site B to be in HREAP/FlexConnect mode.

http://www.cisco.com/en/US/docs/wireless/controller/7.2/configuration/guide/cg_flexconnect.html

Sent from Cisco Technical Support iPhone App

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

Thanks for the reply.

Once i have changed the AP mode to HREAP, do i need to use the DHCP override option or create a new interface to point it to the DHCP server at Site B?

Thanks

Once you change any APs from local to h-reap, you need to define the WLAN to vlan mapping. This is done by clicking on the ap and clicking again on the h-reap/FlexConnect tab. There you will set the nativ vlan and hit apply and go back to that page and click on vlan mapping. You need to set your WLAN to local switching also. All this is documented in the h-reap or FlexConnect deployment guide.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers