Wireless

Hi There,We plan to move our office to a new building. In the new building I expect to have 4 or 5 Access Points (Because of the layout of the building) I would like to have a Guest network and be able to limit the Internet bandwidth on it. (Multiple...

Hello,     I've been searching for awhile, but can't seem to find what I'm looking for. We currently use a basic Web Auth setup for Guest Users, mostly for vendors who come on site. Our support department creates usernames and passwords on our Cisco ...

I know someone out there has the answer for this. I am in the process of installing an Aironet 1140 standalone AP. I have not worked with these AP's before. I will be connecting it to one of the PoE ports on the existing ASA 5505. My goal is to have ...

I've been configuring hundreds of 3602i APs via Prime without incident, but I've encountered 2 APs that get to the ap: prompt and doesn't proceed further.  If I type boot, then they'll complete the boot process.How do I configure these 2 APs so they ...

                   Hi all,    Please help with the following question : we have an existing wireless network (I'm new to this Cisco wireless) and broadcast several SSIDs. Each SSID is in separated VLAN so how do I find and config certain SSID into a ...

All,     Quick question about the association web interface tab on a 1140.  I have noticed that the Device Type shows as "unknown" and the Name shows as "NONE."  Anyone have a clue as to why?  Thanks for any help!     Dave

Hi Everybody,We have a FlexConnect AP in a remote site. The AP has successully joigned the WLC 5508 (runnig 7.4.100.0) through WAN connection, and broadcats an enabed WLAN. However client do not receive DHCP leases and then can not connect properly t...

                   Hi everybody.Two 5508 WLCs running 7.4.100.60. I had to activate HAI decided to configure Service ports: following HA conf guide, I used DHCP. That's because static IPs on service ports are often cleared and forgot during switchove...

Dear Experts,We are in process of deploying ISE 1.2 in our environment for BYOD. The initial step of this process is to configure ISE as an SCEP Proxy and it requires certain configuration on the local CA. We have done all the required configurations...

I need to upgrade WLC5500 series to release 7.4.121.0, but at this moment, WLC manages two AIR-LAP1310G-E-K9, I´m not sure if after upgrade them still work.Are AIR-LAP1310G-E-K9 supported in this version?Regards,EF

Hi,We have deployed some cisco 2602-E access points in one of our clients place. The signal strength found in the laptops is very good, but the signal strength found in the smartphones is very weak and its fluctuating.What is the issue with this and ...