WLC pointing 2 different WLAN's to different DHCP servers

[scdigital]

I have a WLC 2106 which is configured and working as follows:

Site A:

Network: 10.0.0.0/22

3 AP's configured

Radius authentication configured on local server

DHCP handed to clients via local server

Site B:

Network: 10.0.28.0/22

Radius authentication configured on local server

1 AP connected. I have created a new WLAN for this AP

My question is how do i get the AP at Site B to use the local server (10.0.28.x) to hand out DHCP leases?

Thanks

[Stephen Rodriguez]

You would need to configure the AP at site B to be in HREAP/FlexConnect mode.

http://www.cisco.com/en/US/docs/wireless/controller/7.2/configuration/guide/cg_flexconnect.html

Sent from Cisco Technical Support iPhone App

[scdigital]

Thanks for the reply.

Once i have changed the AP mode to HREAP, do i need to use the DHCP override option or create a new interface to point it to the DHCP server at Site B?

Thanks

[Scott Fella]

Once you change any APs from local to h-reap, you need to define the WLAN to vlan mapping. This is done by clicking on the ap and clicking again on the h-reap/FlexConnect tab. There you will set the nativ vlan and hit apply and go back to that page and click on vlan mapping. You need to set your WLAN to local switching also. All this is documented in the h-reap or FlexConnect deployment guide.

Sent from Cisco Technical Support iPhone App