WLC - 'term length 0' equivalent?

[estein]

I'd like to grab the "show run-config" from a WLC, but I want to output it all in one go instead of viewing the output so many lines at a time. On a Cisco switch, router, or IOS AP, you can do a "term length 0" to accomplish this. But I can't figure out how to do this on a WLC! Anyone know?

[ankbhasi · Accepted solution]

Hi Emily,

You can issue a command "config paging disable" and it will give you the output in one go.

HTH

Ankur

*Pls rate all helpfull post

[pchaganu]

"config paging disable" command not available on WLC and device not taking "terminal length 0" command as well.

src-ewlc-1#terminal length 0
Disabling pagination is not allowed on console
src-ewlc-1#

Can you let me know the alternative command ?