WLSE 2.9 and WDS AP's stuck in "Security Keys Setup"

[brian-vachon]

Hey all,

I had to rebuild a WLSE, did a restore from a 2.9 CD. Restore went great, rediscovered all the devices. I am not however getting any rogue or adhoc detection.

I've found that all the WDS servers are stuck in "Security Key Setup". I've tried rebooting all the WDS servers, even the WLSE several times.

I believe that there must be some kind of key mismatch now between the WDS servers and the WLSE.

The usernames and passwords without a doubt match. It is however possible that during the rebuild setup of the WLSE that not all the same information was entered, ie domain name etc.

Does anyone know how to flush the AP's to try and negotiate a new key with the WLSE appliance?

I've tried "clear wlccp nm" and "clear wlccp ap"

Any ideas?

Thanks,

-Brian

[brian-vachon]

Hey all,

Just an update for everyone.

"Security Key Setup" is a good thing, it means the WDS's have registered with the WLSE, so I was barking up the wrong tree there. I thought it meant it was trying to establish the keys.

After some more research I found my problem. Radio Monitoring was not enabled on the WLSE. I reconfigured it and everything is working great now.

Hope this helps someone.

Take care,

-Brian

[rmushtaq]

Security Keys Setup mean that the WDS AP is successfully authenticated with WLSE via the Radius server. This is required before you can use any Radio Management functions in WLSE