WLSE Device Message/ connected to AP on FastEthernet0

richkrissi · ‎10-24-2005

When I highlight one of my APs in Device Center, it says it is connected to one of my other APs on FastEthernet0.

I have several aps but only these two aps show this message that they are connected to one another through FE0.

Can anyone explain why this is?

nhabib · ‎10-26-2005

Go to one of the APs and see if the other one shows up as a CDP neighbor

(you may issue the command: show cdp neighbor)

richkrissi · ‎10-26-2005

All of my ap's show up when I show cdp neighbors.

It doesnt matter what ap I do that on.

I only see this ap to ap connection on two access points for some reason. I have compared configs to others, and see no differences.

akemp · ‎10-26-2005

Perchance do you have WDS configured on either

richkrissi · ‎11-02-2005

I have two aps configured with WDS, but not these. Just recently, this description has changed to two different aps now. I have attached a screenshot with the device highlighted. Hopefully this helps.