WLSE fault message AP is in Overloaded state

[dgatson]

I am running WLSE ver 2.5 with 1200 series access points, IOS ver 12.2(13)JA. I have the WLSE set to monitor associated clients and continue to recieve the fault AP is in Overloaded state (4294967295 associated clients. This only happens with a few AP's. I have compared configs with some of my other normally operating AP's and found nothing. I have been clearing the fault and rebooting the AP, this seems to solve it short-term. Any thoughts and ideas will be apreciated.

[rmushtaq]

It's not a problem with WLSE itself, but a bug with the AP IOS->CSCec89492 which causes this as well as other problems in WLSE, including showing the associated clients in reports as negative. The bug also affects 13JA1. In WLSE you can disable these faults for now as a workaround.

[dgatson]

Thanks for the info. I will wait for an updated IOS.