Workgroup bridge AP 600 or 700 or 1600 series

[mbuillon]

Hello,

I search an AP that can act as Workgroup Bridge. I do not see any information for 600 or 700 or 1600 series.

Can these AP configured in workgroup bridge ?

Regards,

[ageralde]

Hi mbuillon,

Workgroup bridge mode setting is applicable. Is it going to be a controller based set up or just stand alone? Feel free to message me directly for further assistance. 

Thanks,

Angela (ageralde@cisco.com)

[mbuillon]

Hello Angela,

Thank you for this reply because we want to use AP 600 in workgroup bridge mode to interconnect One isolated wired only équipement to the Network througout the existing wireless network.

Is the 600 AP be controlled by WLAN CRTL 2508 in workgroup mode ?

Regards,

[ageralde]

Hi mbuillon,

Do you already have the Aironet 600 in your network? Cisco 2500 wireless controller (http://cs.co/9004cUKI) supports this access point. Please check table 2 for all the controllers supported with the 600 AP. You may message me directly for further details. 

Thanks,

Angela (ageralde@cisco.com)

[mbuillon]

hello,

No, we do not have WLC, we just want to install AP (not LAP) 600 or the new AP 700 in workgroup bridge mode.

Thank for your previous reply Angela

[ageralde]

Hi,

Your welcome. How about the AP 600? 

Thanks,

Angela (ageralde@cisco.com)