I have a problem with some autonomous 1532E AP with version code 15.3(3)JK in a root / non-root deployment.
I have a root ap and a wgb ap with a directly connected plc, since the plc is in a different vlan than the administration one I used the workgroup-bridge client-id command, the thing is that it only works with a wgb scenario, you know if I can do something similar with a root / non-root deployment?
Another thing is that when I set station-role workgroup-bridge, the ap loses more packets than when I set root / non-root. Does anyone have any idea why this happens or if it's just my perception?
In root bridge/ non root bridge scenario, you can make it act as a trunk link. So you can pass any number of vlan as you wish. first part of this blog page give you simple root bridge/non-root bridge configs for couple of vlan.
Yes, but the thing is I have a plc (or could be any endpoint) directly connected to de port of the Non root AP, and as far as I know, end points do not manage tagged traffic right? and the vlan I need to pass is not the native vlan, that's why I used the workgroup-bridge client-vlan command, to force all traffic to that vlan but I want to use non-root mode
Hello Community, I have an issue where APs do not connect to the WLC. Connection is made over VPN. Until yesterday all 3 APfailed with below errors. We change the LAN connection to a cisco router and now one of the AP magically connected to the...
Where to download
Attached files on this post
Alternatively, cloud version (only summaries)
New implementation for the WLC Config Analyzer. it is a new re-write of the application, with clean up and improved checks
Support for IOS...
Cisco Champion Radio · S8|E6: Fastlane+ Optimizes Network and Device Communication
Cisco Fastlane+ is a co-developed solution with Apple that significantly improves the experience of any Wi-Fi 6 capable iPhone or iPad connected to a Cisco Catalyst 9130 A...
We are pleased to announce the immediate availability of the IOS-XE release 17.4.1 for the Catalyst Wireless Controllers. The new code is now posted on the CCO and can be found at this link:
Table of Contents
The purpose of this document is to provide step-by-step instructions regarding how to connect your read-only Catalyst 9800 WLC or AireOS WLC with Cisco DNA Center for Assurance monitoring through manual configuration. I...