WPA on Aironet 350

[nrousseau]

Hello,

I read in the "Release Notes for Cisco Aironet 340, 350, and CB20A Client Adapter Firmware 5.30.17" the following phrase :

"Access points must use Cisco IOS Release 12.2(11)JA or greater to enable WPA"

Does that mean I can't set up WPA with a NetGear AP (wich support WPA-PSK) for example ?

I didn't notice in Aironet 350 Profiles any possibility to enter the Pre Shared Key for WPA authentication, got only LEAP, EAP-FAST and Host Based.

Did I missed something or is it simply impossible ?

Thanks for any help

[mmiklic]

Firmware 5.30.17 supports WPA. ACU 6.2 supports WPA in a limited fashion, i.e. only LEAP is supported for WAP (no WPA-PSK or WPA with EAP-TLS/PEAP). Another WPA supplicant could be used to achieve other WPA auth modes.

BR;Mark

[nrousseau]

Well, I've finaly set up WPA-LEAP with a 1100 AP, it seems to works just fine. For info, WPA with EAP-FAST seems to works also.

Thanks for your answer.