cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
392
Views
0
Helpful
2
Replies

A fatal error was reported by SAR firmware during initialization

Dears,

After upgrading the SMU to one of our IOS XR GSR, we got the following error:

g_spa_2[173]: SPA ATM1/2 SAR: A fatal error was reported by SAR firmware during initialization: Firmware version mismatch [Error code 2002]. SPA will reset

The line card went into constant reload.

I could not locate any bug related.

Could it be hardware issue ?

Thanks,

Michel.

2 REPLIES 2
xthuijs
Cisco Employee

it could be the wrong hw rev for the atm spa is used (I thought you needed a V2).

that could be part of the problem.

alternatively, I would let the SIP boot without the SPA, invoke a fpd update, insert the SPA, try to update the fpd of the SPA, if that still fails, I think you need to open a tac case.

doesnt look like a hw failure to me, but this is a hw issue (fw revision situation)

regards

xander

Xander Thuijs CCIE #6775
Principal Engineer 
ASR9000, CRS, NCS6000 & IOS-XR

zhangyaotian
Beginner

Hi mbousleiman,

 

Sorry to reply here, I want to know the solution for another problem you faced before regarding ASR1K PAT 1:1 translation,as that post already closed.

Please share.indecision

Thanks

Yaotian