XR OS and Platforms

I've been working on trying to get LSM working between a couple of A9Ks to support a SSM based IPTV application.After ingesting a bunch of content on the subject, I think what I want is Partitioned MDT, MP2MP with BGP-AD/mLDP (PIM-free core).  I'm wo...

IP-TELNETD-3-CON_TIMEOUT The telnet connection from x.x.x.x has been Timed out에 대한 설명에 대한 한글 자료입니다. 비슷한 경우가 있는 경우에는 이 문서을 참조하신 후 SR을 열어 주시면 감사하겠습니다.

Hello everybody, I need to know in detail about the hardware configuration of the module ISM (CPU model and RAM, which I don't find in the Cisco documentation). The purpose of the request is to evaluate the possibility of installing propietary SW of ...

Hi All, I am working at small SP. we are going to enable Jumbo Frame support from end to end. Our core segment have MPLS cloud and packet size could be able support  up over 9000 already. Since our Core segment router  are running pure BGP with our e...

  HiI am working on an ASR 9k system and are wondering if there is any possibilities to Police the traffic on the AC -- interface gig0/7/0/10 that is now a L2transport interface, I suppose I can mark and send the traffic over the MPLS network ( Qos s...

Hi Everyone I have some strange resulted as a belowRP/0/RP0/CPU0:CRS-3(config)#interface hu0/5/0/0.1RP/0/RP0/CPU0:CRS-3(config-subif)#service-policy output PQ_WRR_BBRP/0/RP0/CPU0:CRS-3(config-subif)#commitTue Dec 10 17:04:50.072 KST% Failed to commit...

                   I have ASR9K without ISM module with 4.3 IOS-XR. I need to configure the NAT64 on the router. Want to undersatnd whether it is possible without ISM module?

Hi All, I setup IPv6 lab test for MTU size change.  I can see the physical interface and IPv6 interface MTU size are under 9178, but when I did PING test for peering IPv6 adddress, I still could ping through with large packet size up to 18024. I run ...

Hi all, I'm getting the following syslog (also not in standard format) on a 9010 running 4.3.1 + SMUs: RP/0/RSP0/CPU0:Nov 27 05:55:46.484 : fabmgr[222]: Fabric backplane crossbar link underwent link retraining to recover from a transient error: Phys...

Hello all, install a interface card in slot 1 on 0/3/CPU0, however with below error message, try reload the subslot 0/3/1, still can't power up. Do I need reboot the 0/3/CPU0 Mod 80 in order to bring up this module,  or I missed something ?MPA in bay...

Hi, This is document written by Korean to share with Korean partner and custoemr. Thanks,