cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
809
Views
0
Helpful
1
Replies

[Cisco - Huawei] BFD number of times UP: 0

 

# sho bfd ipv6 session detail

Spoiler
I/f: Bundle-Ether1.751, Location: 0/0/CPU0
Dest: 2001:b1:fe0:5::1
Src: 2001:b1:fe0:5::
 State: DOWN for 0d:0h:21m:25s, number of times UP: 0
 Session type: SW/V6/SH/BL
Received parameters:
 Version: 0, desired tx interval: 0 ms, required rx interval: 0 ms
 Required echo rx interval: 0 ms, multiplier: 0, diag: None
 My discr: 0, your discr: 0, H/D/F/P/C/A: 0/0/0/0/0/0
Transmitted parameters:
 Version: 1, desired tx interval: 2 s, required rx interval: 2 s
 Required echo rx interval: 0 ms, multiplier: 3, diag: None
 My discr: 65600, your discr: 0, state DOWN, D/F/P/C/A: 0/0/0/1/0
Timer Values:
 Local negotiated async tx interval: 2 s
 Remote negotiated async tx interval: 2 s
 Desired echo tx interval: 0 s, local negotiated echo tx interval: 0 ms
 Echo detection time: 0 ms, async detection time: 0 ms
Label:
 Internal label: 24072/0x5e08
Local Stats:
 Intervals between async packets:
   Tx: Number of intervals=100, min=1664 ms, max=2001 ms, avg=1832 ms
       Last packet transmitted 127 ms ago
   Rx: Number of intervals=0, min=0 s, max=0 s, avg=0 s
       Last packet received 0 s ago
 Intervals between echo packets:
   Tx: Number of intervals=0, min=0 s, max=0 s, avg=0 s
       Last packet transmitted 0 s ago
   Rx: Number of intervals=0, min=0 s, max=0 s, avg=0 s
       Last packet received 0 s ago
 Latency of echo packets (time between tx and rx):
   Number of packets: 0, min=0 ms, max=0 ms, avg=0 ms
MP download state: BFD_MP_DOWNLOAD_ACK
State change time: Jul 19 11:15:49.202
Session owner information:
                            Desired               Adjusted
  Client               Interval   Multiplier Interval   Multiplier
  -------------------- --------------------- ---------------------
  ipv6_static          500 ms     3          2 s        3        

# ping vrf FT1 2001:b1:fe0:5::1 source 2001:b1:fe0:5::

Spoiler
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 2001:fb1:fe0:5::1, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms

> dis bfd ses all verbose

Spoiler
--------------------------------------------------------------------------------
  (One Hop)   State : Down                  Name : v61
--------------------------------------------------------------------------------
  Local Discriminator    : 16739            Remote Discriminator   : 0
  Session Detect Mode    : Asynchronous Mode Without Echo Function
  BFD Bind Type          : Interface(Eth-Trunk50.751)  
  Bind Session Type      : Static_Auto  
  Bind Peer IP Address   : 2001:B1:FE0:7::                           
  Bind Interface         : Eth-Trunk50.751                                  
  Vpn Instance Name      : Ho1                                  
  Bind Source IP Address : 2001:B1:FE0:7::1   
  FSM Board Id           : 1                TOS-EXP                : 7
  Min Tx Interval (ms)   : 10               Min Rx Interval (ms)   : 10
  Actual Tx Interval (ms): -                Actual Rx Interval (ms): -
  Local Detect Multi     : 3                Detect Interval (ms)   : -
  Echo Passive           : Disable          Acl Number             : -
  Destination Port       : 3784             TTL                    : 255
  Proc Interface Status  : Disable          Process PST            : Disable    
  WTR Interval (ms)      : -                Config PST             : Disable    
  Active Multi           : -                  
  Last Local Diagnostic  : No Diagnostic
  Bind Application       : AUTO | STATICRTV6
  Session TX TmrID       : -                Session Detect TmrID   : -
  Session Init TmrID     : -                Session WTR TmrID      : -
  Session Echo Tx TmrID  : -   
  Session Not Up Reason  : In negotiation  
  Session Description    : -
--------------------------------------------------------------------------------

How should I do?

 

Thank you very much.

1 Reply 1

I found it.

 

Cisco side:

Dest: 2001:b1:fe0:5::1
Src: 2001:b1:fe0:5::

 

but Huawei side:

Bind Peer IP Address   : 2001:B1:FE0:7::                           
  Bind Source IP Address : 2001:B1:FE0:7::1   

 

lol

Thank you very much.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: