cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
249
Views
0
Helpful
4
Replies
Highlighted

Configure broadcast address in subinterface on IOS XR

Hi community

 

I would like to know if someone can help me with some configuration that I need to do in IOS XR, the below configuration is wich I have to migrate to IOS XR, when I try to find some command similar int the subinterface commands for ip broadcast address in IOS XR version 6.5.3 I do not see it.

 

interface GigabitEthernet0/3.100
encapsulation dot1Q 100
ip vrf forwarding THOMSON-MGT-MR
ip address 192.168.83.129 255.255.255.128
ip broadcast-address 192.168.83.255
ip helper-address 192.168.88.166
no ip redirects
ip directed-broadcast

 

Could someone explain me if this command is available in IOS XR? 

 

Thank you so much.

 

Regards

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Participant

Re: Configure broadcast address in subinterface on IOS XR

the broadcast address is not needed

adam

View solution in original post

4 REPLIES 4
Highlighted

Re: Configure broadcast address in subinterface on IOS XR

Can't say that I've seen an XR equivalent of that command.. but I have to ask; do you have devices on the LAN that still requires that?

Highlighted

Re: Configure broadcast address in subinterface on IOS XR

Hi Fredrik

 

I'm not sure if some lan devices require that configuration, I'm going to validate it with the client, I just wanted to know if there was any similar command in XR.

 

Regards

Highlighted
Participant

Re: Configure broadcast address in subinterface on IOS XR

the broadcast address is not needed

adam

View solution in original post

Highlighted

Re: Configure broadcast address in subinterface on IOS XR

Thank you so much for the information.

 

Regards

CreatePlease to create content
Content for Community-Ad

Cisco COVID-19 Survey