Configure broadcast address in subinterface on IOS XR

[AlejandroJuarez03280]

Hi community

I would like to know if someone can help me with some configuration that I need to do in IOS XR, the below configuration is wich I have to migrate to IOS XR, when I try to find some command similar int the subinterface commands for ip broadcast address in IOS XR version 6.5.3 I do not see it.

interface GigabitEthernet0/3.100
encapsulation dot1Q 100
ip vrf forwarding THOMSON-MGT-MR
ip address 192.168.83.129 255.255.255.128
ip broadcast-address 192.168.83.255
ip helper-address 192.168.88.166
no ip redirects
ip directed-broadcast

Could someone explain me if this command is available in IOS XR? 

Thank you so much.

Regards

[Fredrik Lönnman]

Can't say that I've seen an XR equivalent of that command.. but I have to ask; do you have devices on the LAN that still requires that?

[AlejandroJuarez03280]

Hi Fredrik

I'm not sure if some lan devices require that configuration, I'm going to validate it with the client, I just wanted to know if there was any similar command in XR.

Regards

[Adam Vitkovsky · Accepted solution]

the broadcast address is not needed

[AlejandroJuarez03280]

Thank you so much for the information.

Regards