10-09-2012 07:53 AM
Hi,
I have to do a bootflash defragmentation on CRS-3. I already have a procedure but I have a question about the FP-140 cards. As I could see the RP, MSC and FP40 have a bootflash, but I´m not sure if FP-140 has a bootflash.
I ask this because when I apply the show command to check fragmentation state in each FP140 card I get the following error:
0/0/CPU0 FP-140G 14-10GbE IOS XR RUN PWR,NSHUT,MON
RP/0/RP0/CPU0:CRS#show filesystem bootflash: filesys location 0/0/CPU0 | include Stale
Mon Oct 1 16:56:10.115 SCHILE
Unable to open file : No such file or directory
But when I apply the command to another type of card I can see the % of fragmentation:
0/2/CPU0 MSC 8-10GbE IOS XR RUN PWR,NSHUT,MON
RP/0/RP0/CPU0:STGO-LACI-P1#show filesystem bootflash: filesys location 0/2/CPU0 | include Stale
Mon Oct 1 16:56:29.454 SCHILE
Stale : 25896652 Bytes 41%
I hope that somebody could help me.
Thanks,
Jaime.
10-10-2012 01:54 PM
Hi Jaime,
Every SP node has a bootflash.
I would recommend using the show filesystem bootflash: all location 0/0/CPU0 command from admin mode in order to see all the information
Regards,
Sam
10-15-2012 12:26 AM
Hi Jaime, Sam,
no more SP in the CRS-3 line cards (FP140...), all the environmental monitoring is done by an embedded board now.
The bootflash has been replaced by a eUSB of 4GB in the card (lcdisk0: and lcdisk0a:). You don't need to defrag it.
Cheers,
N.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide