FPD

[jameel noori]

(admin)#show hw-module fpd location all

===================================== ==========================================

                                      Existing Field Programmable Devices

                                      ==========================================

                                        HW                       Current SW Upg/

Location     Card Type                Version Type Subtype Inst   Version   Dng?

============ ======================== ======= ==== ======= ==== =========== ====

0/0/SP       FP40                       0.5   lc   rommonA 0       2.05     No

                                              lc   rommon  0       2.05     No

----------------------------------------------------------------------------------------------------------

0/0/CPU0     4-10GBE                    0.80  lc   fpga1   0      15.00     No

                                              lc   rommonA 0       2.05     No

                                              lc   rommon  0       2.05     No

----------------------------------------------------------------------------------------------------------

0/1/SP       FP40                       0.3   lc   rommonA 0       2.05     No

                                              lc   rommon  0       2.05     No

Need to understand diff b/w rommonA and rommon,  will upgrade hw-module fpd all location <x/y/cpu0>”  upgrade both??

[smilstea]

Hi,

If you issue that command all FPDs will be upgraded as your revision is greater than 1.52, before this you would have had to use the hidden command.

http://www.cisco.com/en/US/docs/routers/crs/software/crs_r4.3/rommon/configuration/guide/b_rommon_cg_43xcrs_chapter_0110.html#ID177

HTH,

Sam