06-25-2018 08:15 AM - edited 03-01-2019 03:25 PM
Hi,
According to NCS5500 configuration guide, it doesn't support ABF with VRF select.
Is it the roadmap? If yes, when will it be supported?
Thanks!
c.
Solved! Go to Solution.
06-25-2018 11:18 AM
06-25-2018 08:27 AM
Hi Carlos,
So far it has not been implemented. Can you please help us to understand the use-case for this and why ABF with “IP” or “IP+VRF” NH (which we both support) cannot be used instead.
HTH
Niko
06-25-2018 09:38 AM
06-25-2018 10:51 AM - edited 06-25-2018 10:54 AM
Hi Carlos,
I have some good news. I checked with project team in background and was advised that "VRF-Select" along with "VRF Fallback" will be available from 6.5.1. 6.5.1 is targeted for July/August 2018.
Niko
06-25-2018 11:18 AM
10-08-2018 07:16 AM
Hi Niko,
I can't find this being mentioned in the release notes for 6.5.1. Was VRF-select added for ABF in 6.5.1?
Regards
Sebastian
10-08-2018 07:42 AM - edited 10-08-2018 01:00 PM
Hello,
Unfortunately NCS5501 does not support 6.5.1. 6.5.2 is coming beginning 2019 so lets check on that. I will try to get a hold of a lab to test is as well and let you know.
Niko
10-08-2018 09:02 AM
01-20-2020 07:41 PM
Hello,
Does Cisco official support VRF select with ABF on NCS 5500. I can configure it on 6.5.3.
However documentation mentions its not supported.
ipv4 access-list ABF-TEST-VRF
10 permit ipv4 100.64.0.0 0.0.255.255 host 44.44.44.44 nexthop1 vrf test ipv4 44.44.44.44
15 permit ipv4 14.14.14.0 0.0.0.255 any nexthop1 vrf test
Please confirm. If not supported then possibly target release for this support ?
Regards
Amit
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: